How to Change Oil Filter in Car
Changing the oil filter in a car is not difficult, but it can be messy. This step-by-step guide will help you change your oil filter quickly and easily. All you need to do is gather the necessary supplies before starting this process. The first thing that needs to happen is to make sure there are no leaks at the drain plug of the engine block.
Draining the Oil
Step one is to drain the oil. To do this, first locate where your car’s engine block drain plug is located and take off the bolt with a wrench. It might not be easy at first but it will loosen eventually so keep trying until you can pull it out of place. Once this has been done turn on the hose that allows water to run out of the car when it is washed.
This hose will be located somewhere near where you just removed the drain plug. Once this has been done, put one end in an oil pan and direct the other towards the outside so that all of your old engine oil can flow through it to avoid a mess. Finally, once all of your old engine oil has drained out, replace the drain plug.
Step two is to purchase an oil filter for your car. Once you have bought one, it’s time to do what you came here to do and change the way your engine runs by using this step-by-step guide on how to change a car oil filter.
First put on rubber gloves and gather the supplies you need such as a screwdriver, oil filter wrench and an old towel or cloth. Next locate where your car’s oil filter is located using this guide on how to change a car engine.
Once again take off the bolt with a wrench and remove it from its place. This will allow you access to what needs to be done. Once the old oil filter is out, put in the new one and replace everything you took off earlier to complete this task.
Lubricate the gasket on the new oil filter with fresh motor oil. This helps it to get a tight seal so that no oil can escape. Replace the bolt and tighten until you feel resistance then do one more turn before giving it another try for any leaks.
Then it’s time for step three which will be putting back all of your supplies that were used. Before you leave, make sure that you do a test drive by starting up your car and checking if there are any leaks. If there is none, then your new oil filter has been changed successfully.
Step Four is to pour fresh motor oil into your vehicle’s engine through its cap on top of the car. This way all of the old gunk will be purged and replaced with fresh motor oil.
Once you’ve finished this step, take your car for a drive to allow the engine to run properly and change its way of functioning symbolizing how one can go from old habits into new ones by changing their life around – just like changing an oil filter in a car!
Step Five is to check if there are any leaks under your car. If everything seems to be in order, you have successfully changed the oil filter in your vehicle. If not make sure that all of the bolts were tightened properly and apply some fresh motor oil around each bolt before trying again. Once everything is back on track go for another drive and see what happens.
As you can see, changing the oil filter in a car is not that hard if someone explains everything to do without any instructions. This guide has done just that so follow it and never look back!
Tips: Before starting the step-by-step guide you should gather all of the supplies needed and make sure that no one will be in front or behind where you are working. Next put on rubber gloves, this way it won’t get messy and cause a problem. Be careful when doing this task, don’t drop anything down into the engine.
Remember that oil filters are different for each car and to make sure you bought the right one. Make sure it matches your old filter before starting this process or else there is no point in buying a new one. Also, if after following these steps you experience any problems, you should ask someone who knows how to change an oil filter for help.
Frequently Asked Questions (FAQ)